The default SSID will be “dd-wrt,” and you’ll need to set an admin username and password. If the router is currently plugged into any network, unplug it - we don’t need any Ethernet cables for a repeater. Otherwise, you can proceed full steam ahead with DD-WRT. Look for these options before downloading DD-WRT just to make sure they aren’t available. Fortunately, many of our steps below can be used with native settings that allow it, even if things look different: Linksys, for example, has a different interface, and the method that Netgear’s Nighthawks use is also a bit different, while the Asus mode differs as well. Keep in mind that some router models (especially older routers) do allow you to set up the router as a repeater natively, which means you don’t need to use DD-WRT. When this is done, you’re ready to do some configuring. That’s right: You’re holding the button for 30 seconds with the router on, then 30 seconds with the router off, then 30 seconds with the router on again. Keep the Reset button pressed down for 30 seconds. Step 3: Keep holding the* Reset* button, and plug the router in.

Step 2: Now, while continuing to hold the Reset button, unplug the router. Your router will reset, and this is normal. Step 1: With the router plugged into the power supply, hold the Reset button located on the bottom of the router for 30 seconds. Don’t do them for Linksys EA series routers (as doing so can brick them). Don’t perform them while the router is upgrading. Note: As the DD-WRT Wiki warns, there are situations in which you shouldn’t do a hard reset or 30/30/30 reset. To do this, we do what is called a hard reset - or 30/30/30 reset - which removes all configurations from the NVRAM of your router.

Setting up DD-WRT as a second access pointīefore we configure everything, let’s make sure your DD-WRT router is using the default settings.

Setting up DD-WRT as a wireless repeater.

Enter the IP address, IP subnet mask, and the Gateway IP address that your ISP assigned to you.

In the Internet Address section, select Use Static IP Addresses.

Select Internet (most NETGEAR routers) or Settings (Pro Gaming routers).

The BASIC Home or Dashboard page displays. The user name and password are case-sensitive. The password is the one that you specified the first time that you logged in.

Enter the router user name and password.

Launch a web browser from a computer or mobile device that is connected to your router’s network.

To enter a static IP address on your NETGEAR router: However, some ISPs require you to manually assign a static IP address to connect to the Internet.

Most Internet Service Providers (ISPs) automatically assign an IP address to your router when it connects to the Internet.

Ip address for netgear router extender